GarageChem Engine Chemistry Specialists Ask Us
Home Shop Ceramizator Technology How to Use Lab Results FAQ Contact Ask Us
Home/Shop/Cerator CS-D
Cerator CS-D ceramic oil additive package
Cerator · CS-D

Cerator CS‑D

A ceramic oil additive for diesel engines. The same ceramization technology as CS‑B, tuned for the higher pressures and soot loading of compression ignition.

  • EngineDiesel
  • Protection~62,000 mi
  • PackOne applicator
$29.90
Buy now →

Ships from the US via USPS with tracking. Secure checkout by Stripe.

What it is

Ceramic protection,
bonded into the metal

Diesel engines work their friction surfaces harder than gasoline engines do. Higher compression means higher contact pressures at the piston rings and bearings, and soot in the oil accelerates abrasive wear. CS‑D carries the same nano-particle ceramic technology as CS‑B, formulated for those conditions.

Applied to the engine oil, it reacts at the friction points and builds a hard ceramic-metal layer bonded into the surface. The layer stays after an oil change, which is why a single application covers roughly 62,000 miles. It suits modern common-rail engines and is safe with diesel particulate filters and catalysts.

What changes

  • Lower friction, so less of the fuel's energy is spent on internal drag
  • Improved compression as scoring and high spots are filled in
  • Less oil burned, as the piston-ring-cylinder geometry is restored
  • Easier cold starts — the layer stays on the metal when oil has drained down
  • Quieter, steadier running
  • Reduced CO2 and other combustion by-products

Measured results, including compression and sound-level figures, are on the lab results page.

Using it

How to apply it

01

Warm up the engine

Run the engine until it reaches normal operating temperature — about 15 minutes. The ceramization reaction is driven by heat, so a cold engine is the wrong moment to apply.

02

Switch off and add Cerator

Turn the engine off, then add the correct dose through the engine oil filler cap. This is an oil additive — it does not go in the fuel tank.

03

Start the engine, do not drive

Restart and let it run for 15 minutes without moving the vehicle. This circulates the product through the lubrication system before any load is applied.

04

Drive gently, up to 124 miles

Drive normally but without labouring the engine for the first 124 miles (200 km), and do not exceed 3,000 RPM during this period.

05

Full protection at 932 miles

The ceramic-metal layer is fully formed after approximately 932 miles (1,500 km) of driving. After that, drive as you normally would.

Dosage

How many
applicators?

Set by your engine's oil capacity and its mileage. One box contains one applicator.

Engine mileageOil 2.1–10.6 qtOil 10.6–21 qtOil 21–32 qt
0 – 62,000 mi½ applicator1 applicator2 applicators
62,000 – 186,000 mi1 applicator2 applicators3 applicators
Over 186,000 mi2 applicators3 applicators4 applicators

Most passenger cars hold between 4 and 6 quarts, so a typical car past 62,000 miles needs one applicator. Not sure? Send us your vehicle details and we will tell you.

Wrong fuel type?

Looking for the gasoline version?

Cerator CS‑B is the same technology, formulated for gasoline engines. Same price, same single application.