GarageChem Engine Chemistry Specialists Ask Us
Home Shop Ceramizator Technology How to Use Lab Results FAQ Contact Ask Us
Home/Shop/Cerator CS-B
Cerator CS-B ceramic oil additive package
Cerator · CS-B

Cerator CS‑B

A ceramic oil additive for gasoline and LPG engines. One applicator, added to the engine oil, rebuilds worn friction surfaces and protects them for roughly 62,000 miles.

  • EngineGasoline
  • Protection~62,000 mi
  • PackOne applicator
$29.90
Buy now →

Ships from the US via USPS with tracking. Secure checkout by Stripe.

What it is

Ceramic protection,
bonded into the metal

CS‑B is the original black applicator and the product most people start with. Its formula uses intelligent nano-particles with high surface activity: carried by the engine oil, they reach the points where metal slides against metal, react with the surface under friction heat, and build a hard ceramic-metal layer exactly where wear is happening.

That layer is bonded into the metal rather than suspended in the oil, which is why one application lasts tens of thousands of miles and survives oil changes. It is compatible with every gasoline engine and with any motor oil — conventional, semi-synthetic or full synthetic — and it is safe for engines fitted with catalytic converters.

What changes

  • Lower friction, so less of the fuel's energy is spent on internal drag
  • Improved compression as scoring and high spots are filled in
  • Less oil burned, as the piston-ring-cylinder geometry is restored
  • Easier cold starts — the layer stays on the metal when oil has drained down
  • Quieter, steadier running
  • Reduced CO2 and other combustion by-products

Measured results, including compression and sound-level figures, are on the lab results page.

Using it

How to apply it

01

Warm up the engine

Run the engine until it reaches normal operating temperature — about 15 minutes. The ceramization reaction is driven by heat, so a cold engine is the wrong moment to apply.

02

Switch off and add Cerator

Turn the engine off, then add the correct dose through the engine oil filler cap. This is an oil additive — it does not go in the fuel tank.

03

Start the engine, do not drive

Restart and let it run for 15 minutes without moving the vehicle. This circulates the product through the lubrication system before any load is applied.

04

Drive gently, up to 124 miles

Drive normally but without labouring the engine for the first 124 miles (200 km), and do not exceed 3,000 RPM during this period.

05

Full protection at 932 miles

The ceramic-metal layer is fully formed after approximately 932 miles (1,500 km) of driving. After that, drive as you normally would.

Dosage

How many
applicators?

Set by your engine's oil capacity and its mileage. One box contains one applicator.

Engine mileageOil 2.1–10.6 qtOil 10.6–21 qtOil 21–32 qt
0 – 62,000 mi½ applicator1 applicator2 applicators
62,000 – 186,000 mi1 applicator2 applicators3 applicators
Over 186,000 mi2 applicators3 applicators4 applicators

Most passenger cars hold between 4 and 6 quarts, so a typical car past 62,000 miles needs one applicator. Not sure? Send us your vehicle details and we will tell you.

Wrong fuel type?

Looking for the diesel version?

Cerator CS‑D is the same technology, formulated for diesel engines. Same price, same single application.